86-021-54178789
Block B1, No. 6638, Beisong Road, Songjiang District, Shanghai, China (Mainland)
Model | 400G-SA-1 |
Power | 96W |
Rated voltage/frequency | 110V-220V, 50/60HZ |
Output Capacity | 1514L/Days |
Water pressure | 0.1-0.6Mpa |
Feed water temperature | 5-45℃ |
Treatment stages | 5 stages (Also can be added in mineral,alkaline,UV light) |
| 1st Stage | 10" PP 5 micron filter, Clear filter housing |
| 2nd Stage | 10" GAC carbon filter, White filter housing |
3rd Stage | 10" CTO carbon Block Filter, White Filter Housing |
| 4th Stage | RO membrane |
5th Stage | 10" in-line post carbon cartridge |
Pressure tank | no tank |
| Filter Housing | Double O-ring filter housing |
| Booster Pump | 110V or 220V |
| Faucet | Press-handle gooseneck faucet 1/4" or Three-way Handle Long Reach Faucet 1/4" |
| Fittings type | Quick fittings |
Other parts | Solenoid valve 1/4'' or Auto Shut-off Valve 1/4'' |
High pressure switch, Low pressure swith | |
| 1/4" tubing for system connection | |
| Feed water connector, 1/4" ball valve | |
| Drain water clip | |
| Each components have been passed 10,000 times strict cycle testing |
Color | White or silver |
Packing | 590*430*340mm |
Specificaton:
(1)Capacity: 400G
(2)Flush type: automatic flush
(3)Power supply:110V/220V , 60Hz /50HZ
(4)RO membrane: FS-DO.F
(5) Booster Pump: pump with adaptor
(6)Fitting type: Quick Push connector
Filter Cartridge Lifetime:
Stage 01--5 micron PP cotton filter: 4 tons, replace in 6 months
Stage 02--particle coconut activated carbon: 4 tons, replace in 6 months
Stage 03--1 micron PP cotton filter: 8 tons, replace from 6 to 12 months
Stage 04--reverse osmosis membrane: 28-36 tons, replace in 3 years
Stage 05--post inline coconut activated carbon: 8 tons, replace from 6 to 12 months8 tons
Precautions:
(1) Never place the water purifier in a direct sunshine
(2) Move the machine carefully and lightly.
(3) The water purifier shall operate at a temperature of 5-42°c,,and must not filter hot water,otherwise this may cause damage;in winter,pay attention to heat preservation and
protect against freeze.
(4) By using a cloth dipped in water,clean the water purifier with soft detergent rather that strong
volatile solvent such as gasoline
(5) In case of failure,disconnect the water source promptly,and see the introduction or ask us.
(6) In case of Long-term no use.pull the power plug,close the feed ball valve and cut off the water
source.
(7) In the cases where the water purifier is used for the first time or resued after long time idle
drain out the first two tanks of water through the goosennect tap after the tank is full,and then
use the machine.
(8) Don’t use a power supply that does not match the related voltage
